注：你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的4指南。
正翻译步骤 11
步骤 11
Remove the left thumbstick assembly
-
Insert the flat end of a spudger between the bottom right edge of the thumbstick assembly and the chassis.
-
Pry up the thumbstick assembly and remove it.
-
Orient the board over your device thumbstick side down.
-
Thread the thumbstick ring cable through its cutout on the board.
-
Lift the right edge of your device and push the thumbstick assembly firmly into place so the small circular cutouts on the right edge go over their alignment posts. The board should stay firmly in place.
您的所有投稿皆享有基于开源创作共享许可协议（CC BY-NC-SA）的著作权利。